Factory:  Corner Steyr & Alfa Sts 
Aureus Industrial sites 
Email: info@keramicalia.co.za
Website: www.keramicalia.co.za
Cell: Dave  082  808 4757
Email: keraccounts@iafrica.co.za
Accounts: Myrtle Wakeford
Tel: (011) 764 2139
Tel: (011) 412 3261
P O  Box 2288
Wilro Park,1731

An abrasion resistant material

Maximum service temperature;   1250°C

Composition;   Fused alumina, 80% Al₂O₃

Density;   2,6g/cm³

Cold crushing strength; air dry: 100 MPa      110°C: 120 MPa       1000°C: 150MPa. (+8%H₂O)

Applications:   Sliding or impact abrasion resistance, wet or dry. See detailed instructions below.

Mixing:   Add +8% water by puddling in a bakery mixer, 10kg batches, read instructions below.

Packaging: 10kg plastic bags

Development no. 85765

Kerabrade S is installed usually 15mm thick onto a steel shell to delay wear of the shell.  To optimize adhesion to the shell, the plaster is anchored to expanded metal. The preferred grade of expanded metal is Mentex 72. The expanded metal may be raised slightly off the shell. To do this the expanded metal is bent outwards at the desired intervals for welding. To bend it, cut a short (about 9mm) piece of pipe of diameter approximately 55mm. Weld this to a rod about 800mm long. Place the expanded metal on a concrete slab. Slide the pipe under the expanded metal to the point to be bent out. Strike the expanded metal sharply with a hammer until it reaches the concrete. This results in bumps raised about 5mm, which can now be welded to the shell.