Factory:  Corner Steyr & Alfa Sts 
Aureus Industrial sites 
Email: info@keramicalia.co.za
Website: www.keramicalia.co.za
Cell: Dave  082  808 4757
Email: keraccounts@iafrica.co.za
Accounts: Myrtle Wakeford
Tel: (011) 764 2139
Tel: (011) 412 3261
P O  Box 2288
Wilro Park,1731

This is a liquid solution of binders.  The solution is designed for very rapid drying and is flammable.


APPLICATIONS:  Hardening of moulds, especially foundry sand moulds in areas where there is high turbulence.

It also allows sodium silicate bonded moulds to be stored for up to a year before use.

Mould hardener can be brushed on or sprayed on.  Use between ½ a litre and 2 litres per m².

This will give a penetration of between 1mm and 4mm.

Hardening will occur as soon as the solvents have evaporated.  To speed up the drying, ignite the surface with a match.

Clean the spraying equipment or paint brushes thoroughly with solvent after use.

Application by a "swab" or rag is convenient, if the equipment can be burned after use.

This stuff is seriously sticky, and it usually pays to wear gloves when working with it.

If you struggle to get it all off your hands, just dry your hands well, as with a hot air blower, and once dry the stickiness almost disappears.

Read the safety data sheet.

Development no.  102600